Radio over Fiber — Hybrid combiner 2 coax + 4 fibers
ACH-642
Close over coax, far over fiber, same receivers.
The ACH-642 is a 4:2:2 diversity hybrid combiner in a 19" rack. It combines one pair of local antennas over coax, with 12 V DC feed, and up to two pairs of remote antennas over fiber through two AFB-250, into two BNC outputs. Four optical loss indicators, 110 – 220 V mains power.
Combining
2 coax + 4 fibers → 2 BNC
Coax band
470 – 850 MHz
Fiber band
470 – 690 MHz (AFB-250)
Coax channel gain
+3 dB typ.
Format
19" rack · 3.5 kg
Highlights
Near and far, combined
One pair of local antennas over coax and up to two pairs of remote antennas over fiber (two AFB-250), summed onto two diversity BNC outputs, A and B.
4:2:2 · 2 coax + 4 fibers
Optical loss indicators
Four Optical In LEDs, one per fiber: on when the signal is good, blinking between 3 and 6 dB of loss, off beyond.
4 LEDs · 3 – 6 dB
DC feed on the coax channels
12 V / 200 mA on each coax input for active antennas, short-circuit protected and switchable off per channel (internal switch), for example for a magnetic loop antenna.
12 V · 200 mA · protected
In detail
The ACH-642 is a diversity hybrid antenna combiner (2 coax, 4 fibers). It remotes up to two pairs of receiving antennas over four single-mode optical fibers and combines them with one pair of local antennas connected to the base by coaxial cable. It is used with one or two AFB-250: three diversity antenna pairs can then be placed strategically to improve RF coverage.
Signals are combined into two 50 Ω BNC outputs, A and B, feeding one or more diversity receivers or a splitter. Coax channels have +3 dB typical gain, fiber channels 0 dB; fiber channel bandwidth is that of the AFB-250, 470 – 690 MHz.
The coax channels have a 12 V / 200 mA DC feed, short-circuit protected, switchable off per channel with an internal switch. Most passive antennas work with the DC feed on; for a magnetic loop antenna, switch it off. A DC feed LED blinks in case of a short circuit in the cable or antenna.
Four Optical In LEDs show the state of the optical signal coming from the AFB-250: on when the signal is good, blinking when attenuation is between 3 and 6 dB, off beyond.
Optical inputs are OpticalCon Duo APC; connection through LC/APC patch cords is possible. Use APC connectors (green) only, unless a PC adaptation is requested.
Specifications
The numbers that matter.
Condensed excerpt. See the datasheet for detailed conditions.
RF
Fiber & power
Mechanical
Use cases
Multi-zone
Cover the venue and two remote zones
One pair of coax antennas in the venue, two AFB-250 in the remote zones: the ACH-642 combines the three pairs into the booth's diversity receivers.
Extension
Add fiber to a coax installation
Keep the existing coax antennas and add fiber antennas where coax can't reach. An unused coax channel: DC feed off and a 50 Ω load on the BNC.
Coverage
Place antennas without coverage holes
Start with a single pair, walk the area, then add a pair where signal is missing. Avoid placing two antennas of the same channel (A or B) close together: risk of multipath fading.
Configurations
Used in these setups
Documentation
Everything you need before buying.
Datasheets and user manuals available in PDF format.