Optical fiber: connectors, polishing and cleaning

3 min read

Optical fiber is now at the heart of modern telecommunication systems. Thanks to its very low losses and its immunity to electromagnetic interference, it has become the ideal solution for carrying RF signals over long distances.

A short history of optical fiber

Optical fiber was first used in the 1950s in the medical field, with the endoscope. In 1970, Corning developed a fiber with an attenuation of about 20 dB/km, making it possible to transmit information over long distances.

Today, modern single-mode fibers show typical losses below 0.5 dB/km, and several hundred million kilometers of fiber are produced every year.

How it works

Optical fiber guides light through total internal reflection. A fiber is mainly made of:

  • an optical core;
  • an optical cladding;
  • a protective coating.

The light signal injected into the core travels with very little loss.

Multimode fiber

In a multimode fiber, light follows several paths at the same time.

AdvantagesDrawbacks
Lower costLimited bandwidth
Easier alignmentShorter distances
Modal dispersion

Single-mode fiber

In a single-mode fiber, only one propagation mode is used. Its advantages:

  • very high bandwidth;
  • long distances;
  • low losses;
  • excellent RF transmission quality.

Professional Radio over Fiber systems mainly use single-mode fibers.

At BSRF. BSRF equipment is used with single-mode fiber.

Optical connectors

There are several optical connector standards: LC, SC, ST and FC.

ConnectorCharacteristics
LCCompact, allowing a high connection density. Widely used in data centers, telecom equipment and modern RF systems.
SCRugged and very common in optical patch bays.
STHistorically used in some video and industrial applications.
FCScrew-on coupling with good resistance to vibration.

APC, UPC and PC polishing

The quality of the polish on the fiber end face has a strong impact on optical performance.

PolishEnd face
PC (Physical Contact)Flat polished surface. Usually a blue connector body.
UPC (Ultra Physical Contact)Slightly domed surface that reduces reflections.
APC (Angled Physical Contact)Surface polished at a typical 8° angle. Usually a green connector body.

Advantages of APC polishing:

  • very low back reflection;
  • better RF quality;
  • fewer optical disturbances.
At BSRF. BSRF systems use APC connectors to achieve the best possible performance. The equipment can, however, be adapted for use with PC fibers.

Inspection and cleaning

The cleanliness of optical connectors is critical. A single speck of dust can cause:

  • higher optical losses;
  • spurious reflections;
  • degradation of the RF signal being carried.

For this reason, fibers must be:

  • inspected regularly;
  • cleaned with suitable tools;
  • protected when not in use.

Inspection

Inspection is usually carried out with a dedicated optical microscope.

Cleaning

Cleaning relies on:

  • special wipes;
  • cleaning sticks;
  • suitable solvents;
  • "one-click cleaner" tools.

That is why BSRF products use the Neutrik OpticalCon as their standard connector: it is fitted with shutters and can also be used with LC connectors.

Mastering inspection and cleaning ensures optimal performance of BSRF products.

What about Radio over Fiber?

The principle, the advantages over coax and the applications of Radio over Fiber are covered on our Radio over Fiber page.