RF Distribution — Compact active 2:6 splitter
AS-62
Two antennas, three receivers, in a sound bag.
The AS-62 is a compact diversity active antenna splitter: two BNC inputs, three SMA outputs per antenna, for three diversity receivers. Filtered wideband 470 – 700 MHz, 39 dBm OIP3, two-step RF Peak, protected 12 V DC feed. 83 × 60 × 31 mm, 250 g.
Configuration
2 BNC in → 2 × 3 SMA out
Bandwidth
470 – 700 MHz
DC feed
12 V / 200 mA
Form factor
83 × 60 × 31 mm · 250 g
Highlights
Bag-sized
Two antennas to three diversity receivers, in a housing that fits a sound bag or a cart. 4-position stainless clip supplied.
83 × 60 × 31 mm · 250 g
Wideband 470 – 700 MHz, filtered
Filtering rejects signals below and above the band; wideband, so no block constraint. Analog and digital modulation.
No frequency block
High-dynamic amplifiers
0 dB ±1 dB gain, input up to +20 dBm, noise figure below 2 dB, output isolation above 25 dB.
OIP3 39 dBm · NF < 2 dB
Two-step RF Peak
Per antenna, two LEDs: yellow, level to keep an eye on; red, level not to hold, risk of saturation and intermodulation.
Yellow −15 dBm · red −5 dBm
Protected DC feed
A · OFF · A+B switch to power active antennas or a booster. Current limiting per input; the DC-feed LED blinks on short circuit or over-current.
12 V · 200 mA · A / A+B
In detail
The AS-62 is a diversity active antenna splitter (1 BNC to 3 SMA per channel) for three diversity receivers. Compact and rugged, it is made for the field: sound bag or small cart.
Its filtering rejects signals below and above the 470 – 700 MHz band. The circuits are wideband: no frequency block constraint, analog and digital modulation.
A two-step RF Peak indicator per antenna flags an RF field that is too strong: yellow, keep an eye on it; red, do not hold. Too strong a signal saturates the active circuits, generates noise and intermodulation and shrinks the coverage.
Passive or active antennas connect to the BNCs. The 12 V / 200 mA DC feed, controlled by the A · OFF · A+B switch, is current limited on each input; its LED blinks on short circuit or over-current.
12 – 18 V power on a 4-pin Hirose connector. 4-position stainless clip supplied. Unused outputs must be terminated with a 50 Ω SMA load.
Specifications
The numbers that matter.
Condensed excerpt. See the datasheet for detailed conditions.
RF
Inputs / outputs
Power
Mechanical
Use cases
Sound bag
Three diversity receivers from two antennas
Antennas A and B on the BNCs, three SMA outputs per antenna to three diversity receivers. 50 Ω loads on unused outputs.
Active antennas
Power the antennas from the splitter
12 V DC feed on the BNCs for active antennas or a booster. Antenna gain should compensate the coax loss, no more, or it will saturate the distribution.
Levels
Spot an RF field that is too strong
The RF Peak LEDs flag an antenna too close to a transmitter before noise or intermodulation shrinks the coverage.
Documentation
Everything you need before buying.
Datasheets and user manuals available in PDF format.