RF Distribution — Active 2:12 splitter
AS-122
Two antennas, six receivers, on the cart.
The AS-122 is a diversity active antenna splitter: two filtered BNC inputs, six SMA outputs per antenna, for six diversity receivers. 470 – 700 MHz band, 1.5 dB noise figure, regulated and protected 12 V DC feed, two-step RF Peak. 88 × 84 × 44 mm, 265 g.
Configuration
2 BNC in → 2 × 6 SMA out
Bandwidth
470 – 700 MHz
Regulated DC feed
12 V / 200 mA
Form factor
88 × 84 × 44 mm · 265 g
Highlights
Six diversity receivers
Two antennas on BNC, six SMA outputs per antenna. AC-coupled outputs; 50 Ω loads on unused outputs.
2 × 6 SMA
Filtered, low-noise inputs
370 – 700 MHz band at −3 dB, +1 dB ±1 dB gain, 1.5 dB noise figure. Analog and digital modulation.
370 – 700 MHz · NF 1.5 dB
Regulated, protected 12 V DC feed
A · OFF · A+B switch for active antennas or a booster, and to compensate cable loss. Current limiting per input; the DC-feed LED blinks on short circuit or over-current.
12 V · 200 mA · A / A+B
Two-step RF Peak
Per antenna: green, level to keep an eye on; red, too strong a level not to hold, risk of intermodulation.
Green −20 dBm · red −6 dBm
Aluminium housing, bag-sized
Bag or cart. 10 – 18 V power on 4-pin Hirose, 4-position stainless clip supplied.
88 × 84 × 44 mm · 265 g
In detail
The AS-122 is a diversity active antenna splitter (1 BNC to 6 SMA per channel) for six diversity receivers. Its compact aluminium housing is made for shoots: bag or cart.
The inputs are filtered; 470 – 700 MHz band at −3 dB, +1 dB ±1 dB gain, 1.5 dB noise figure. Analog and digital modulation.
Passive or active antennas connect to the BNCs. The regulated 12 V DC feed, 200 mA max, controlled by the A · OFF · A+B switch, powers active antennas or a booster to compensate the cable loss. Each input has its own current limiting: the DC-feed LED blinks on short circuit or over-current.
A two-step RF Peak indicator per antenna flags an RF field that is too strong: green, keep an eye on it; red, do not hold. Too strong a signal saturates the active circuits and generates intermodulation.
10 – 18 V power on a 4-pin Hirose connector. 4-position stainless clip supplied. Outputs are AC coupled; unused ones must be terminated with a 50 Ω SMA load.
Specifications
The numbers that matter.
Condensed excerpt. See the datasheet for detailed conditions.
RF
Inputs / outputs
Power
Mechanical
Use cases
Sound cart
Six diversity receivers from two antennas
Antennas A and B on the BNCs, twelve SMA to six diversity receivers, DC feed for active antennas.
Active antennas
Compensate the cable loss
The DC feed powers active antennas or a booster whose gain compensates the coax loss, no more, so as not to saturate the distribution.
Levels
Spot an RF field that is too strong
The RF Peak LEDs flag an antenna too close to a transmitter before noise or intermodulation shrinks the coverage.
Documentation
Everything you need before buying.
Datasheets and user manuals available in PDF format.