Radio over Fiber — Hybrid transmission base
ATH-200
Your transmitters, local and over fiber.
The ATH-200 is a 1U hybrid transmission base for one or two transmitters, from 100 to 1000 MHz. Each input comes out locally on a BNC and is combined onto fiber toward one or two AFB-350. Gain adjustable per fiber output, from −24 to +7 dB.
Bandwidth
100 – 1000 MHz
Inputs
2 × BNC + 2 direct outputs
Input power
30 – 500 mW
Fiber gain
−24 to +7 dB
Fiber outputs
1 + 1 optional
Highlights
Local and over fiber
Each input comes out directly on its local BNC, with 2 dB typical loss, and both signals are combined onto the fiber for the remote AFB-350.
2 direct coax outputs · 2 dB
One or two remote zones
Neutrik OpticalCon Duo APC 1310 nm output as standard; the optional second one connects two AFB-350. LC/APC connection possible.
1 fiber output + 1 optional
Adjustable gain per fiber output
One front-panel trimmer per fiber output sets the power at the AFB-350 output. Manual mode by default, or automatic gain control on a stored reference.
−24 to +7 dB
Front-panel LEDs
Power On; Optical On, internal optical modules T1 and T2 working; RF in 1 and 2, signal detected above 20 mW.
Power · Optical On · RF in
In detail
The ATH-200 is a hybrid transmission base for one or two carriers, toward coax antennas and antennas remoted over single-mode optical fiber. It is used with one or two AFB-350 boxes.
Two transmitters connect to the base, 30 to 500 mW each. Each input signal comes out directly on a local coax output, with 2 dB typical loss, and both signals are combined onto the optical output(s).
One Neutrik OpticalCon Duo APC 1310 nm optical output comes as standard; a second one is available as an option, required to connect two AFB-350. LC/APC connection is also possible.
Two front-panel trimmers set the gain of each fiber output, from −24 to +7 dB, and so the power at the output of the matching AFB-350. Gain works in manual mode (default) or automatic: a reference is stored and the automatic gain control holds the output power.
Front-panel LEDs: Power On, Optical On (T1, T2) and RF in (1, 2), lit from 20 mW at the input. Mains power 110 – 220 V, 19" rack, 1U.
Specifications
The numbers that matter.
Condensed excerpt. See the datasheet for detailed conditions.
RF
Fiber & power
Mechanical
Use cases
IEM
Remote the IEM transmit antenna
IEM transmitters → ATH-200 at the booth → fiber → AFB-350 close to the stage. The local coax outputs remain available for a booth-side antenna.
Multi-zone
Cover three zones with the same transmitters
Zone 1 over coax from the local outputs, zones 2 and 3 with one AFB-350 each (2nd fiber output option). Mic reception follows the same path with AFB-250 and ACH-642.
Level setting
Set the remote power from the booth
One trimmer per fiber output sets the power at each AFB-350 output, from −24 to +7 dB. In automatic mode, the stored reference is held if the transmitter level changes.
Configurations
Used in these setups
Documentation
Everything you need before buying.
Datasheets and user manuals available in PDF format.