Radio over Fiber — Transmit antenna box
AFB-350
A transmit antenna, at the end of the fiber.
The AFB-350 is a fiber transmit antenna box: it receives an ATH-200 signal over one single-mode fiber and drives a remote transmit antenna with its built-in amplifier, 500 mW on one carrier, from 100 to 1000 MHz. SWR indicator, XLR4 power.
Bandwidth
100 – 1000 MHz
1-carrier power
500 mW (27 dBm)
2-carrier power
100 mW
IMD3
−45 dBc
Noise density
−113 dBm/Hz
Highlights
Transmit antenna over fiber
The AFB-350 receives an ATH-200 signal over one single-mode fiber and drives a remote transmit antenna, instead of a long coax run.
Fiber → amp → antenna
Built-in amplifier
Wideband 100 – 1000 MHz amplifier: 500 mW (27 dBm) on one carrier, 100 mW on two, 10 mW on four. IMD3 −45 dBc with two carriers at 20 dBm.
500 mW · 100 mW · 10 mW
SWR indicator
SWR (standing wave ratio) shows how much power is reflected back by the antenna. Green: antenna well matched. Yellow: some reflection, acceptable. Red: too much reflection, check the cable, the antenna or the filter's frequency range.
Green · yellow · red
In detail
The AFB-350 remotes a transmit signal over one single-mode optical fiber. Electro-optical components specially made for radio over fiber are used in this equipment. It is used with the ATH-200 base.
Its rugged aluminium enclosure and its connectors are designed for field operation.
The AFB-350 has a built-in wideband amplifier with a maximum output power of 27 dBm (500 mW) on one carrier. Several carriers can be amplified at reduced power per carrier: 100 mW for two, 10 mW for four.
An SWR indicator shows the output state (green, yellow or red depending on reflections). An Optical In indicator shows whether the AFB-350 receives the optical signal from the ATH-200 base.
Power is supplied on XLR4 (pin 1 −, pin 4 +), from 12 to 36 V DC; a linear power supply is advisable. The optical input accepts a Neutrik OpticalCon APC or LC/APC cord.
Specifications
The numbers that matter.
Condensed excerpt. See the datasheet for detailed conditions.
RF
Fiber & power
Mechanical
Use cases
IEM
Remote the IEM transmit antenna
ATH-200 at the booth → fiber → AFB-350 near the stage → transmit antenna. Fiber replaces the coax between booth and antenna.
Multi-zone
Cover two zones with the same transmitters
One ATH-200 feeds two AFB-350, each with its antenna in a different zone: IEM or intercom in both zones.
Simplex
Re-emit an FTX-1 signal
An FTX-1 in low sensitivity carries a transmitter over fiber; the AFB-350 re-emits it on a remote antenna.
Configurations
Used in these setups
Documentation
Everything you need before buying.
Datasheets and user manuals available in PDF format.